Loading... Please wait...

Hover over image to zoom

  • Steve's Stiffies - 71" 3DHS Slick Side Panel Reinforcements - pair
  • Image 2
  • Image 3
  • Image 4

Steve's Stiffies - 71" 3DHS Slick Side Panel Reinforcements - pair

1
$11.95

 Product Description

Pair of Steve's Stiffies, these are carbon fiber reinforcements braces for the side panels of your 71" Slick, glues right where the wing bolt goes and greatly increases the strength of the fuselage side panel area

 

Developed by my good friend Steve T.in response to multiple reports of the side panels ripping out in hard maneuvers and made right here in the USA and now sold exclusively at 3dRCparts.com

 

Instructions for installation: 

Slide a pencil (or other rod that fits the screw hole in the side of the fuselage). Slide one of the "stiffie's onto the pencil from the inside, with the small tab of plywood at the top and facing towards the outside of the plane, just to make sure it fits onto the "ledges" on the top and bottom stringers. If it fits fine (which is should, but it "could" need a bit of length adjustment with a sanding block), then remove the stiffie and put a little thick CA on the plywood and on the carbon fiber at the bottom and slide it back on the pencil, and hold in place until the CA cures....repeat on the other side..

 Find Similar Products by Category

Vendors Other Products

 Product Reviews

Write review

This product hasn't received any reviews yet. Be the first to review this product!

Current Stock:
1
1

newsletter

Click the button below to add the Steve's Stiffies - 71" 3DHS Slick Side Panel Reinforcements - pair to your wish list.